Product Details
[Medical mouth mask]
• Single piece pack
Highly efficient protective filter layer
Filtration efficiency ≥ 95%
• Five-layer structure
From outside to inside are: nonwoven + hot air cotton + meltblown cloth + meltblown cloth + nonwoven
• Three-dimensional design
Built-in noseband
[National standard, professional tests]
GB 19083-2010 GB 19083-2010
[Detail display of sheet]
[Technical Data]
Product name: Medical protective mask
Type: Duck beak type, arc type, fold type. (Sterile)
Technical data: L (large), M (medium), S (small)
Structure: It consists of mask body, nose clip and mask bands.
[Product Performance]
The mouth mask covers the mouth and nose of the wearer and is precisely on the face. There are no holes, spots on the surface and ensures fluid breathing. The nose clip is adjustable. The mask covers are also easily adjustable It should be sufficient force to fix the position of the mouth mask. The breaking strength at the connection point of each mask band and mask body should not be less than 10 N. Although the gas flow is 85 l/min, the filtration efficiency of the oral mask for non-oil particles should not be less than 95% and the inhalation resistance of the mouth mask should not exceed 343.2 Pa. Spray 2 ml of synthetic blood at a pressure of 10.7 kPa on the mask, and there should be no penetration into the mouth mask. The water level of the outer surface of the mouth mask should not be below class 3 in GB / T4745-1997. The materials used are non-flammable. The continuous burning time is lower than 5s. Mouth masks should be sterile. After the product has been sterilized with ethylene oxide, the mask design should provide good adhesion and the overall adjustment factor of the mouth mask should not be less than 100, the remaining ethylene oxide should not exceed 10 micrograms/g.
[Scope]
It is used in the medical working environment to prevent the spread of viruses from the patient to the medical staff, to filter particles in the air, to block droplets, blood, bodily fluids, secretions, etc.
[Use Method]
Open the pack. Remove the mouth mask. Touch and check the position of the nose clip. Wear the mouth mask and make sure the nose clips are on top. Press the noseband with the fingertip along the bridge of the nose from the center to the sides to adjust the nose clip and adjust it on the face.
[Filtration Efficiency Level]
The filtration efficiency for non-oil particles is not less than 95%.
[Contraindications]
No. Those who are allergic to the material of this product must use with caution.
[Notes, Warnings, and Tips]
1Press the nose clip tightly so that the mouth mask is tightly attached to the face.
2. Use prohibited if the packaging is damaged.
3. This product is a disposable product and must not be reused.
4. Dispose of the product after using the product as medical waste.
5. The product should be disposed of if it is damaged, the respiratory resistance increases or is contaminated by blood or bodily fluids. In addition, the time of use laid down by the hospital's infection control rules or local regulations should be respected.
Storage conditions: Store at room temperature and avoid light radiation.
Usage period: Two years.
GB19083-2010 Implementing Standard: GB19083-2010
[About Company]
Laboratory
Manufacturing workshop protective mask
http://www.en.huibode.com/
Company Profile
